Watering forty pots by hand is fine in February. By May, when a grow bag on an open terrace can dry out between breakfast and lunch, it becomes a daily chore that decides if you can leave home for two days. A small drip system takes that job off your hands. It puts water at the root zone of each pot, wastes less, and keeps the terrace floor drier.

This guide is part of our balcony and terrace gardening in India series. It explains the parts of a DIY drip kit, the difference between running drip from a tank and from a tap, how to lay it out for pots and grow bags, how long to run it in each season, and how to keep the drippers from clogging.

Drip emitter on a small stake fed by a thin micro tube, dripping water into a pot of clay pebbles. Photo: Alan.ca, Public domain, via Wikimedia Commons.

How drip irrigation works on a terrace

Drip irrigation, called tapak sinchai in Hindi, sends water through a main pipe and lets it out slowly through small outlets placed at each plant. Instead of a jug of water rushing through the pot in a few seconds, the mix gets a slow trickle that has time to soak in. On a terrace this has three clear benefits. Less water runs out of the drainage holes onto the floor, leaves stay dry, which helps in humid weather, and every pot gets watered at the same time each day even when you are away.

Drip does not decide how much water a plant needs. You still have to set the run time, check the pots and change the schedule with the season. Think of it as a reliable pair of hands, not a brain.

Parts of a DIY drip kit

Ready-made terrace kits and loose parts are both easy to find. Jain Irrigation's published terrace and home garden kit, for example, lists a tap adaptor, a small on/off valve, 16 mm tube, an inline filter, 4 litre per hour drippers, four-way stake sets, end stops, joiners, tees, elbows, a punching tool and goof plugs. Most kits from other brands use the same family of parts.

16 mm lateral pipe

This black pipe is the backbone. It runs along your row of pots and carries water from the source. It is flexible, cuts with a sharp knife or pipe cutter, and joins with barbed tees, elbows and joiners. Close the far end with an end stop, often a small figure of eight clip, so you can open it later to flush the line.

4 mm micro tube

The thin tube, sometimes called spaghetti tube, carries water from the 16 mm pipe to each pot. You punch a hole in the lateral, push in a small barbed connector, and run the micro tube up into the pot. It lets you keep the main pipe on the floor and still reach pots on stands, railings and hanging baskets.

Five round button drippers in red, yellow, green and white, the kind pushed into a 16 mm drip pipe. Photo: Borisshin, CC BY-SA 4.0, via Wikimedia Commons.

Drippers and emitters

The words are used loosely, but they mean the outlet that controls how fast water comes out. You will see a few kinds:

Filter

A small inline screen or disc filter near the source stops sand, rust and bits of plastic from reaching the drippers. TNAU's drip irrigation guidance calls filtration the main factor in whether a system succeeds or fails. Never run the system with the filter element removed.

Timer

A battery tap timer opens and closes the water on a schedule. Before buying, check two things on the box: the minimum water pressure it works at, and whether the thread fits your tap. Some solenoid timers will not open properly on the low pressure of a terrace tank line.

Gravity drip from a tank or bucket

A gravity system needs no pump and no electricity. Water flows from a raised tank, drum or bucket through a valve and filter into the pipes. The pressure comes only from height. As a rough guide, each metre of height between the water level and the drippers gives about 0.1 bar.

Jain's bucket kit instructions ask for the water source to sit at least 1.5 metres above the ground, and FAO's guide to family drip kits describes tanks set 1 to 1.5 metres high. In practice this means:

Water is heavy, so a full drum on a stand puts a lot of weight on one small patch of roof. Ask a structural engineer or your builder where to place it, ideally over a beam or column. If your terrace has not been checked yet, read our guide on terrace garden waterproofing before you add a tank and a garden.

Running drip from a tap

Many terrace taps in Indian homes are fed by the overhead tank, which sits only a short height above the terrace floor. That tap works much like a gravity system, so the same low pressure rules apply. A tap connected to a pressure pump or a strong direct supply is different. It gives enough pressure for compensating drippers and long runs, but it can also blow fittings off, so many installers add a pressure reducer.

If your area gets municipal water only at fixed hours, a timer on a tap connected straight to the supply will only work when water is in the line. Running drip from a tank you fill daily is more reliable in that case.

Laying out drip for pots and grow bags

Black drip pipes laid in loops along garden beds of tulips and daffodils, fed by a hose through a splitter with small shut-off valves. Photo: Przemek Pietrak, CC BY-SA 3.0, via Wikimedia Commons.

Plan in zones

Plants that need very different amounts of water should not share one line. A tomato or brinjal in a big grow bag in full sun drinks far more than a jade plant or an aloe. Make separate lines with their own small valve: one for summer vegetables, one for flowering shrubs, and one for slow drinkers, or leave succulents off the system altogether.

Pots

Run the 16 mm lateral along the base of the row, close to the parapet but not blocking the drain outlets. For each pot, take a micro tube from the lateral to a stake dripper placed a few centimetres from the stem, not right against it. A four-way splitter lets one dripper feed four small pots that sit close together.

Grow bags

A small bag with herbs or chilli usually needs one dripper. A large bag with brinjal, tomato or a gourd vine does better with two, placed on opposite sides of the plant, so the whole root ball gets wet and not just a narrow column. Our guide to grow bags vs pots explains why fabric bags dry faster than plastic pots, which matters when you set run times.

Raised pots, railings and hanging baskets

Micro tube can climb a wall or a railing and be clipped in place. Keep these pots on their own line if you can, because water drains back down after the system shuts off, and a high basket can end up drier than the pots below it.

Start-up and first test

Before you fit the end stops, open the line and let water run through for a minute to flush out dirt and air. Then close the ends and walk along the row to see that every dripper is working. If you punched a hole in the wrong place, close it with a goof plug.

How long to run drip in each season

There is no single right number. It depends on dripper flow, pot size, the mix, the plant and the weather that week. The way to find your number is a simple test.

  1. Water a dry pot with the system and time it.
  2. Stop when water just starts to come out of the drainage hole.
  3. Note the time, then check the soil with your finger the next day to see how fast it dries.

A little arithmetic helps too. A 4 litre per hour dripper running for 15 minutes gives about 1 litre. Two of them in one grow bag give about 2 litres in the same time.

Summer (March to June)

This is when drip earns its place. On an open terrace in North India during dry, windy weeks, most vegetable pots need water every day, and small pots may need a second short run. ICAR's heat wave bulletin from 2022 advises running drip twice a day, morning and evening, for tomato during heat waves. Run the first cycle early in the morning. Black lateral pipes lying in the sun heat the water inside, so the first water out in the afternoon can be hot. Laying the lateral in the shade of the pots helps. For more on getting plants through the hot months, see our guide on how to protect plants from heat.

Monsoon (June to September in most places)

Switch the timer to manual or turn it off on rainy days. Pots under an open sky may need nothing for a week. Pots under a balcony roof still need water, so check them separately. In coastal Karnataka, Kerala, Konkan and Mumbai, where rain is heavy and steady, overwatering is the bigger risk.

Winter (November to February)

In North India, cool days and short sunlight mean pots dry slowly, and many need water only every two to four days. Cut the run time and the number of days. In Chennai and coastal Andhra, the northeast monsoon brings rain from October to December, so treat those weeks like the monsoon. In Bengaluru, Pune and Hyderabad, winter is mild and dry, so you will still water regularly, just less than in April. Our guide to plant care in winter covers the other changes for the cold months.

Hills

In Himachal, Uttarakhand and the higher parts of the northeast, summer is the main growing season, and the pre-monsoon weeks of May and early June can be very dry. In winter, where nights drop below freezing, drain the lines so water does not freeze inside the pipes and fittings.

Keeping drippers from clogging

Clogging is the most common reason people give up on drip. TNAU lists the usual causes as solid particles like sand and rust, soft matter like algae and slime, and salts that settle out of the water. Hard water from many borewells leaves white crusts that slowly close the tiny holes.

A simple home routine

Hard water deposits

If drippers have white crust, pull them out and soak them in plain white vinegar for a few hours, then rinse and refit. Replace any that stay blocked. On farms, systems are treated with acid or chlorine on a schedule, but that needs care and correct dosing, so for a home terrace, cleaning and replacing drippers is safer.

Liquid feeds and drip

Thick homemade liquid feeds such as compost tea or jeevamrut carry fine particles that block drippers. Apply these by hand with a mug or watering can. Jain's kit leaflet also warns against adding fertiliser to a tank that is used for general household water.

Common mistakes

Watch: a basic drip setup for pots

This short Hindi video shows a low-budget drip setup for pots, from fixing the main line to connecting each plant with a feeder tube. Your layout and run times will depend on your own terrace, water source and plants.

Video: Drip Irrigation System Installation Guide | How to Setup Drip Irrigation for Beginners in Low Budget, by Funtime With Honey on YouTube.